The adsorption effluent curve of benzene by activated carbon was plotted.
The effects of different temperature on the regeneration performance of activated carbon under static environment, the effects of steam at different temperature on the regeneration performance of activated carbon under dynamic environment and the effects of nitrogen at different temperature on the regeneration performance of activated carbon under dynamic environment were studied.In domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.[activated carbon is a kind of very small granular has a large surface area, and more tiny holes in the granular - capillary. The capillary has very strong adsorption capacity, due to the granular surface area is large, so a good contact with with gas (impurities). When these gases (impurities) encounter capillary by adsorption, purification effect. Activated carbon surface area of the study is very important, only the BET specific surface area detecting data of active carbon method detected result is reliable, domestic at present there are many instruments can only make direct comparison method of detection,In domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.www.wyactivatedcarbon.com
F - Sorb 2400 specific surface tester is really able to BET method detection instruments (both direct comparison method), the more important F - Sorb 2400 specific surface tester is by far the only specific surface area of the fully automated intelligent testing equipment, the test results with the international high consistency, the stability is very good also, at the same time reduce the human error, improve accuracy test results.In view of the characteristics of large amount of matter and high content of benzene organic matter in gas, the method of removing these substances is studied and the solution is given.
In this study, the concentration of benzene, naphthalene and ash in gas before purifying feed-gas compressor was determined by chromatograph, picric acid titration and weighing method respectively. According to the measured values, the experimental flow was designed, and coke column and activated carbon column were made by themselves.bulk powdered activated charcoal
The isobarisothermal adsorption properties of activated carbon at different temperatures, at different pressures and at different flow rates were determined by using the gas produced in the system as samples.
Welcome to GTR Culture Forums
|
|
Guest Message by DevFuse |
Page 1 of 1
Activated carbon top raw materials for sale and processing Ding Xin Da global high quality activated carbon supplier
Share this topic:
Page 1 of 1