Study on Preparation of Modified Activated Carbon and Its Adsorption Performance of Heavy Metals

Welcome to GTR Culture Forums

Welcome to GTR Culture Forums, like most online communities you must register to view or post in our community, but don't worry this is a simple free process that requires minimal information. Take advantage of it immediately, Register Now or Sign In.

Start new topics and reply to others
Subscribe to topics and forums to get automatic updates
Add events to our community calendar
Get your own profile and make new friends
Customize your experience here

Guest Message by DevFuse

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Study on Preparation of Modified Activated Carbon and Its Adsorption Performance of Heavy Metals Dingxinda global quality activated carbon supplier

#1 CLMcar

Advanced Member

Group: Members
Posts: 744
Joined: 07-March 21

Posted 15 September 2021 - 10:40 PM

In view of the characteristics of large amount of matter and high content of benzene organic matter in gas, the method of removing these substances is studied and the solution is given.
In this study, the concentration of benzene, naphthalene and ash in gas before purifying feed-gas compressor was determined by chromatograph, picric acid titration and weighing method respectively. According to the measured values, the experimental flow was designed, and coke column and activated carbon column were made by themselves.
The isobarisothermal adsorption properties of activated carbon at different temperatures, at different pressures and at different flow rates were determined by using the gas produced in the system as samples.
The adsorption effluent curve of benzene by activated carbon was plotted.
The effects of different temperature on the regeneration performance of activated carbon under static environment, the effects of steam at different temperature on the regeneration performance of activated carbon under dynamic environment and the effects of nitrogen at different temperature on the regeneration performance of activated carbon under dynamic environment were studied.
The experimental results showed that high pressure and low temperature were beneficial to the adsorption, and the flow rate had little effect on the equilibrium adsorption capacity in the range of experimental flow rate. The adsorption capacity of benzene by activated carbon in the experiment was 150~170mg/g under operating conditions.activated carbon manufacturers in china
At the same time, the filtration and adsorption properties of coke were tested.https://www.granular...ted-carbon.com/
The experiment shows that the adsorption performance of the tactivated carbon pellet wholesale
The results show that the combined use of coke and activated carbon in the gas system can completely achieve the purpose of removing benzene, naphthalene and ash.
According to the above research results, a coke filter was designed. The application of the equipment solved the problems that the feedstock gas compressor in the urea blackening unit could not run for a long period due to the vibration caused by the scaling of the rotor, the blockage of the flow channel and the problems that the naphthalene formation in the heat exchanger affected the heat transfer effect.coal based activated carbon factory
The preliminary design of the adsorption device was carried out. From the comparison of operating cost and product output value, the economic benefit was remarkable, and the pollution of benzene to the environment was eliminated.